Even placing them inside a simple vase would bring a smile to my face.
But I especially like the look of the leaves with these soft, pretty pink Spring bushes.
The polka-dotted ribbon is the finishing touch to this super-simple and girly wreath.
Create your own fun ribbon using any stencil template of your choosing!
you’re able to readour full disclosure policy here.
Dip the stencil brush in the paint and blot off the excess paint.
Peel away the stencil and reposition it along another section of the ribbon.
Continue until the entire ribbon length is stenciled.
Leave the ribbon to dry fully before using.
Next fold the ribbon lengthwise in half tucking in the cut edges approximately 12 on either end.
Using a sewing needle and thread, begin to sew the loop closed to form the center loop.
Next, take the long stencilled ribbon and fold in half lengthwise to mark the center point.
Lay the ribbon on a flat surface, stenciled side facing down.
Fold the ends inward at the midway point criss crossing them at the center.
Precut a piece of floral wire approximately 5 long.
Pull one end of the wire through the loop as well.
This wire will be used to attach the bow to the wreath.
Precut a piece of floral wire.
Add more floral wire if needed to secure the eucalyptus sprig in place.
To protect your fingers from the cut wire, you could wear a pair of gardening gloves.
Add some additional faux floral bunches on top and secure them in place with more floral wire.
Create another small loop with the ends of the floral wire to use for hanging the wreath.
Hang your new simple Spring hoop wreath and enjoy!
This post originally appeared onCrafts by Amanda.
Pin it for later!