Youve seen these slices already in ourBirch Bark Votive Holderpost.
I was curious whether heat embossing onto the wood slices would work.
The powder adhered beautifully and a set of ornaments was born!
We tried to find a Christmas themed stencil of the right size but were strangely unable to do so.
Carefully cut out each character to make small stencils.
Position the stencil over the wood slice where youd like to see the final placement.
Gently, using a paint brush, brush on a thin coat of Mod Podge.
Lift off the stencil and sprinkle a solid coat of embossing powder over the entire painted-on image.
Turn the slice over and firmly tap off all the excess powder.
Warm up your heat gun for 20-30 seconds, then when ready carefully apply to the wood slice image.
Be careful to not burn your fingers!
Once I got the hang of it, I was able to do a few at a time.
To finish the ornament just add on a beautiful ribbon for hanging.
They would also look lovely next to our littledriftwood reindeer ornaments.
